Plaster

Thistle Hardwall

An undercoat plaster with high impact resistance and quicker drying surface. Suitable for application by hand or mechanical plastering machine to most masonry backgrounds.

Thistle Multi-Finish

This versatile final coat plaster provides good results on all suction backgrounds, and is therefore the best choice for plastering where both undercoats and board backgrounds are involved on the same job. It is also ideal for small jobs and patching.

The ideal final coat plaster for low-medium suction backgrounds such as plasterboard and Thistle Dri-Coat.

Gyproc Dri-Wall Adhesive

A general purpose gypsum-based adhesive. For use with British Gypsum DriLyner systems, on high, medium or low suction backgrounds.

Paper joint tape bonded to two corrosion resistant metal strips, for manual application only. Supplied in a cardboard dispenser. For reinforcing external angles in plasterboard construction, and ideal for internal or external angles that are not 90º.

Thistle Bonding Coat

An undercoat plaster for low suction backgrounds (e.g. concrete and plasterboard or surfaces treated with bonding agents).

Gyproc Easi-Fill

A combined setting and air drying gypsum based material for bulk filling and finishing of joints. High coverage rate and minimal drying shrinkage allows application in only two coats. Easy to mix, apply and sand, with 90 minutes working time and the second (final) coat can be applied after 120 minutes. Used in the 2-stage method of plasterboard jointing.

An air drying, powdered jointing material. Used in the traditional 3-stage jointing process. Designed for the finishing stage over Gyproc Joint Filler in hand jointing, or for all application stages with mechanical jointing tools.

An air-drying, ready-mixed jointing material. Used in the traditional 3-stage jointing process. Designed for the finishing stage over Gyproc Joint Filler in hand jointing, or for all application stages with mechanical jointing.

High performance plaster bonding agent - specially formulated for use on smooth backgrounds.
For use on smooth backgrounds e.g. concrete with Thistle Bonding Coat, or for re-skimming.
No dilution - so no scope for errors, no time spent mixing, no confusion on site.
Always used in one coat only - so no decisions to take about background porosity etc.
Contains fine aggregates for better mechanical, as well as chemical adhesion.
Green in colour - so it's easy to see where it's been applied.
Plastered when dry - so no difficult timing to get right.
The only product recommended for use with Thistle Bonding Coat plaster.